Installing the lithium memory battery, Removing the lithium battery, Note – Sharp VIEWCAM VL-WD650U User Manual

Page 28

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Preparation

Installing the Lithium Memory
Battery

Installing the Lithium Battery

The supplied lithium battery is used to store the

memory of the date and time settings.

i 1

Press the LCD monitor OPEN release
button (®) and open the LCD monitor
(®).

® I

------ monitor OPEN

'‘‘‘ase button

Open the lithium battery compartment
door using the tip of a ballpoint pen or
other pointed object.

Insert the lithium battery into the

compartment with the + side facing out.

Replace the compartment door, and

close it firmly until it clicks into place.

Close the LCD monitor until it clicks into
place.

Removing the lithium battery

Perform steps 1 and 2 above.
Lift up the battery using a
pointed object, and take it out.

Note:

• Replace the battery with a new CR2025 lithium

battery when the time indicator of the camcorder

starts to fall behind the correct time.

Notes on the Use of the Lithium

battery

REPLACE BATTERY WITH TOSHIBA,
MATSUSHITA OR HITACHI MAXELL TYPE

CR2025 ONLY. USE OF A DIFFERENT

BATTERY MAY PRESENT A RISK OF FIRE OR
EXPLOSION.

iWJsMIlM KEEP THIS BATTERY AWAY FROM

CHILDREN. IF SWALLOWED, CONSULT A

PHYSICIAN IMMEDIATELY FOR EMERGENCY

TREATMENT.

■WaillWWi BATTERY MAY EXPLODE IF MIS

USED OR INSTALLED WITH POLARITY
REVERSED. DO NOT RECHARGE, DISAS

SEMBLE OR DISPOSE OF IN FIRE.

• Do not short-circuit, recharge, disassembie, or

heat the iithium battery.

• Shouid the lithium battery leak, wipe the battery

compartment clean, and then insert a new

battery.

• The lithium battery will last about one year under

normal usage.

This manual is related to the following products: