Sharp VIEWCAM VL-WD650U User Manual
Page 59
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Press
press ^
R E M O T E
or ► / II to select “ON”, then
ON
4
Press the MENU/DISPLAY button to
turn off the menu screen.
Operating the Remote Control
1
Open the LCD monitor completely (®),
then rotate it 180° vertically (®).
2
Set the Media Selection switch on the
camcorder to TAPE or CARD.
3
Set the Power switch on the camcorder
to CAMERA or VCR.
4
Aim the remote control at the remote
sensor of the camcorder, and press the
control buttons for operation.
REW button
[pp. 23, 78]
CARD REC button
[p. 74]
TAPE REC START/STOP button
[p. 20]
ZOOM W/T buttons
[pp. 21,60]
VOL. ~/+ buttons
[p. 23]
PLAY button
[pp. 23, 78]
FF button
[pp. 23, 78]
STOP button
[pp. 23, 78]
SLOW button
[p.45]
Shift buttons
[p. 60]
Advance/reverse buttons
[p.45]
PAUSE/STILL button
[pp. 25, 45]
Notes:
• Be careful not to allow direct sunlight or bright
light from interior illumination to fall onto the
remote sensor, as this may prevent the remote
control from operating properly.
• Be sure that there are no obstacles between the
remote control and the remote sensor.
• When the batteries are depleted and the remote
control does not operate, replace them with new
AA (R6 or UM/SUM-3) batteries.
$
E
44