Attaching and removing the battery pack – Sharp VIEWCAM VL-WD650U User Manual

Page 25

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Attaching and Removing the

Battery Pack

Attaching the Battery Pack

Make sure that the Power switch is set

to OFF.

Lower the viewfinder.

Lift up the viewfinder.

Power source

mounting surface

Align the - mark on the side of the

battery pack with the ◄ mark on the

camcorder (®), and slide the battery

pack down completely until it locks into
place (®).

■D

■g

Removing the Battery Pack

Perform steps 1 and 2 above.

Press the power source PUSH release
button (®), and slide the battery pack
up and take it out (®).

Power souroe PUSH

release button

Cautions:

• BEFORE REMOVINGTHE BATTERY PACK,

ALWAYS STOP RECORDING OR PLAYBACK
AND TURN THE POWER OFF.

Removing the

battery pack while shooting or during playback
may damage the tape by causing it to wrap

around the video head drum or may destroy the
SmartMedia card, rendering it unreadable and

unwritable.

• Remove the battery pack from the camcorder if

you will not use the camcorder for a long period
of time.

• Use only SHARP model BT-L221 or BT-L441

battery packs with this camcorder. Use of other
batteries may present a risk of fire or explosion.

This manual is related to the following products: