Brother FAX-200 - Manual (Page 35)

2 6
**'*’******'********************
XMT VERIFICATION MM/DD/YY HH:MM
*****'*"*'*■*'******■*■******■*■***★ **■**
* DESTINATION : BROTHER INDUSTRIES *
* MODE G3 STANDARD *
* PAGE(S) : 01 *
* RESULT : OK *
*******************************************
BROTHER FAX-200
********************************************
NOTE 1: Only when the transmit report function (XMT VERIFICATION) is set to ON and
your document was properly transmitted, the unit prints out the above report.
NOTE 2: If a communication error occured, a communication error report (see p. 38) is always
printed out whether the transmit report function is ON or OFF.
NOTE 3: If the line was busy and your document was not transmitted, neither the above
report nor a communication error report is printed out.
E. Selecting the Password Transmission mode
NOTE: The FAX PASSWORD permits transmission to you by units with the same matching
pass-code. Use this feature if you are part of a closed network or if fax "junk mail" is a
problem. Registration of the passcode is described in ADVANCED OPERATIONS
below.
1. Press "6" in the USER SWITCH SELECTION MODE. The LCD will display:
PASSWORD:OFF — AUTO ANS
PASSWORD
2. Select the ON or OFF mode using the cursor keys.
PASSWORD-.ON — AUTO ANS
■- PASSWORD
3. If you press SET, the PASSWORD TRANSMISSION MODE is selected and the
display returns to the USER SWITCH SELECTION MODE.
If you press NEXT, the the PASSWORD TRANSMISSION MODE is selected
and the display proceeds to the next user switch (SELECT AUTO ANSWER &
NUMBER OF RINGS).
If you press STOP, the display returns to the standby mode without
registration.
If you have set Password into ON position, the LCD shows at the proper position in
standby mode.
01/01/89 00:00
AUTO ANS
PASSWORD
Important: Unless necessary, leave the Password Transmission OFF to permit
communication with non-Brother units.