Brother FAX-200 - Manual (Page 31)

22
IV. SETTING UP THE AUTO DIALER
A. Registering One-Touch Numbers
You can register ten (10) one-touch numbers (up to 22 digits each) and destination names (up
to 20 characters each) for convenient dialing.
1
.
3.
5.
6 .
8 .
9.
Press FUNCTION and "1". Now you are in the REGISTRATION & SETTING
mode.
REGISTER(0-9)?
2. Press "3". The LCD will display:
— AUTO ANS
■- PASSWORD
- AUTO ANS
^ PASSWORD
Select a digit from 0 to 9 under which you will register the one-touch number
For example, press "1". The cursor will move the the next digit of
FXfì:
FX1: • AUTO ANS
• PASSWORD
Use the numeric ten key pad to enter the appropriate telephone number, e.g.:
-AUTO ANS
^ PASSWORD
FX1:201
Use PAUSE to register a pause for PBX or overseas transmissions.
- AUTO ANS FX1:201 P
PASSWORD
If you try to enter a telephone number of more than 11 digits, the display will
scroll to the left.
X1:201P981P0300. — AUTO ANS
PASSWORD
If you wish to add a destination name (up to 20 characters), follow the
instructions in Step 8.
Otherwise, if you do not touch any key for around 10 seconds, the one-touch
number will be registered automatically and the LCD will revert the standby
mode.
Press NEXT. This registers the fax (telephone) number, and now you can
register the name attached to the one-touch number. The LCD will show:
NAME: — AUTO ANS
PASSWORD
Use the chart on page 21 to input up to 20 characters.
To continue one-touch diai registration, press NEXT. The destination name is
registered, and the LCD will show
FX1:201P981P0300
10. Select another digit, for example, 2.
FX2:
■ AUTO ANS
• PASSWORD
•AUTO ANS
• PASSWORD
11. Repeat the steps 4-8.