Brother FAX-200 - Manual (Page 16)

V. INSERTING THE ORIGINAL DOCUMENT TRAY
The original document tray consists of document tray, Call Directory and Quick-Reference Card,
and wire paper holder. The Call Directory Card and the Quick-Reference Card can be inserted
into the back side of the tray in the following step.
1. Turn the tray face down. Also hold the Call Directory Card and the Quick-Reference Card
face down. Insert either left or right leg (positioned at the bottom of the Cards) into the
slit of the tray and then insert another leg. See Illustration 1 below.
2. Slide the Cards down along the slits. Put the upper part of the Cards below the two
protrusions coming out face to face at the top middle of the tray. (The tray must still face
down.) Slide the Cards down to the bottom of the slits.
3. Now turn the tray face up.
A wire paper holder also comes with this tray and can be easily installed into the tray. Locate
small holes at the top of the tray. Insert the legs of the paper holder into the holes. Make sure
the other end of the wire protrude upwards as shown below. Pre-installation is complete.
Insert the above tray into the slots at the top of the unit as shown in the Illustration 2 below.