Brother FAX-200 - Manual (Page 29)

III. REGISTERING YOUR COMPANY NAME/DESTINATION NAME
You can register up to 22 (twenty two) alphanumeric characters for your company name/ ID.
• Press NEXT after you've registered the RTI/TTi. The LCD displays:
20
NAME; • AUTO ANS
■ PASSWORD
Input is accomplished by using the character chart on the next page. Please note that
you must use the 2-digit code for each alpha or numerical character in your station ID.
When the input for the STATION ID has been completed, pressing NEXT will return you
to the RTI/TTI setting. And if you do not touch any key for around 10 seconds after you
have entered your STATION ID, it will be automatically registered and the LCD will
revert to the standby mode.
Clearing a Registered Company Name / Destination Name
• To clear a company name/destination name, bring the name up on the LCD again:
NAME:£ROTHER — AUTO ANS
^ PASSWORD
Enter the 2-digit code for a blank (0,0) using the ten key pad. This erases the
registration entirely. The LCD shows:
NAME: ■AUTO ANS
■ PASSWORD
Correcting Mis-registration
• To change a character already registered, move the cursor under the character to be
changed, then oven/vrite the character with the correct 2-digit code. For example, if you
input BRATHER instead of BROTHER, bring the cursor to "A" and enter the 2-digit
code for "O". The correction will be shown on the display.
• To correct a missing character, move the cursor to the place where the character is
missing and put in the 2-digit code for the missing character. Then reinput all
characters succeeding the missing character. For example, if you entered BRTHER and
forgot the "O", move cursor under the "T" then input 2-digit code for "0","T", "H", "E"
and "R".
Please see the chart on the following page.