Cleaning the shuttle race – Kenmore 385.15208 User Manual

Page 68

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Cleaning the Shuttle Race

This area must be kept free of dust, lint and tangled thread-

Clean the shuttle race area every three months.

«Cleaning the shuttle area

(T) Bobbin case
(2) Levers

Shuttle race cover

(J) Shuttle

Shuttle race

1. Raise the needle bar to its highest point, then and

remove the bobbin case ®.

2. Push the shuttle race levers @ aside. Lift out the shuttle

race cover© and take the shuttle ©out.

3 Clean the shuttle race ® with a lint brush.
4. Put a drop of oil on the center pin of the shuttle © and

the shuttle race (5). Do not over oil.

® Replacing shuttle assembly

1. Turn the handwheel so the shuttle driver ® forms a

half moon on the left side of the machine.

2. Hold the shuttle ® by its center pin®, and position the

shuttle so it forms a haif moon on the right side. The
hook® will be on the bottom.,

3., Put the shuttle race cover® back into place over the

shuttle assembly.