Kenmore 385.15208 User Manual
Page 54
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Overcasting Stitch
© stitch pattern selector:
3
(2) Presser foot:
Zigzag foot
(D
Needle thread tension:
1 to 4
@ Stitch length dial:
1 to 2
® Stitch width dial:
5
This stitch is useful in garment construction, and in finishing
the raw edges of any sewing project.
Start overcasting about 1/8”(0,3 cm) inside the raw comer
of a fabric. The right tip of the stitch should just clear the
row edge.
Multiple Zigzag Stitch (Mode! 15208 exclusive)
© Stitch pattern selector:
4
© Presser foot:
Zigzag foot
© Needle thread tension:
1 to 4
© Stitch length dial:
1 to 4
® Stitch width dial:
5
»Seam finishing
Place the fabric under the presser foot in such a manner
that the edge is slightly inside the right-hand side of the
presser foot. Guide the fabric so that the right hand
stitches fall at the edge of the fabric,,
Trim the excess close to the stitches. Be careful not to cut
the stitches.
«Mending
Position the tear under the needle, so that the stitch
catches both sides.
46