Bobbin winding, Bobbin winding -22 – Kenmore 385.15208 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Bobbin Winding
• Removing bobbin case
Remove the extension table from the machine by pulling
it to the left. Open the shuttle cover© by puiling down
the embossed part on the left of the cover
Raise the needle to its highest position by rotating the
handwheel toward you.
© Shuttle cover
(D
Bobbin case
To remove the bobbin case©from the shuttle, pull open
the latch of the bobbin case. Pull the bobbin case straight
out of the shuttle.
• Bobbin winding
[T]
Release the clutch by pulling out the handwheel. This
will stop the needle from moving while you wind the
bobbin.
d] Draw thread from the spool.,
[
3
] Guide the thread around the thread guide,
[
4
] Thread through the hoie in the bobbin from the inside to
the outside.
{
5
] Put the bobbin on the bobbin winder spindle.
18