Stitch pattern selector, Stitch length dial, Stitch width dial – Kenmore 385.15208 User Manual

Page 38: Reverse stitch control

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

stitch

Pattern Selector

Stitch pattern selector

The stitch pattern selector determines the stitch you select.

NOTE;

^ ""

To avoid needle or fabric damage, make sure the needle

is up and out of the fabric while selecting a stitch.

Stitch patterns are color-coded to recommended setting

zone on the stitch length control.

ZONES:

Red:

Straight, zigzag and utility stitches

Green: Geometric decorative stitches
Blue:

Built-in buttonhole

H {Model 15208)

ifr (Model 15202)

Stitch Length Dial

©Setting mark
Turn the stitch length dial until the setting mark reaches the
desired stitch length. The higher the number the longer the
stitch. “ 0 ” means “no feed”,

• “ CZ3 ” is the recommended setting for buttonhole

stitching.

“ Adjust the stitch length dial in the 0.5-4 range when you

sew the zigzag stitch.

NOTE:

Study the red, green and blue zones on the stitch length
control. These are recommended zones of stitch length
and are color-coded to the stitches.

Stitch Width dial

Turn the stitch width dial until the setting mark reaches the

desired stitch width.

The higher the number, the wider the stitch width.

When the stitch width is narrow, the right side of the
pattern will be cut off (model 15208),

Example: Pattern 5 Width [5|

Width [3]

NOTE:

Raise the needie above the fabric, when you turn the
stitch width dial.________________________________

Reverse Stitch Control

Press the stitch control to sew in reverse.