Kenmore 385.15208 - Manual (Page 14)

SECTION II. GETTING READY TO SEW
Connecting Machine to Power Supply
Ф Power supply plug
@ Power switch
©Outlet
(4) Machine socket
© Machine plug
© Sewing light
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power,
1, Turn off the power switch ©,
2, Insert the machine plug© into the machine socket (§).
3, Insert the power supply plug ф into the outlet ©,
4, Turn the power switch© to activate the power and
sewing light®.
Before Using Your Sewing Machine
Before using your sewing machine for the first time, place a
waste fabric under the presser foot and run the machine
with thread for a few minutes. Wipe away any oil which may
appear.
For Your Safety
* While in operation, always keep your eyes on the sewing
area Do not touch any moving parts, such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
- When leaving the machine unattended
- When attaching or removing any parts
- When cleaning the machine
* Do not place anything on the foot control, when not
sewing.
Polarized Plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of an electric shock, this plug
is intended to fit in a polarized outlet only one way If the
plug does not fit in the outlet, reverse the plug, If it still does
not fit, contact a qualified electrician to install the proper
outlet. Do not modify the plug in any way.
Foot Controller Model YC-482J or TJC-150 is used with
Sewing Machine Model 385,15202XXX and 385,15208
(XXX represents numbers 000 through 999).
I
Controlling Sewing Speed
Sewing speed can be varied by the foot control ,
The harder you press on the foot control, the faster the
machine runs.