Threading the machine – Kenmore 385.15208 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading the Machine
• Threading the machine
* Raise the thread take-up lever to its highest position by
turning the handwheei counterclockwise.
* Raise the presser foot lifter.
* Place a spool on the spool pin, with thread coming off as
shown.
|T|
Draw the end of thread around the upper thread guide,
While holding the thread near the spool, draw the end of
the thread down around the check spring holder.
[U Firmly draw the thread up and from right to left over the
take-up lever then down into the take-up lever eye.
[4] Slide the thread behind the needle bar thread guide on
the left.
fsl Thread the needle from front to back.
• Drawing up bobbin thread
[T] Raise the presser foot. Hold the needle thread lightly
with your left hand.
j Rotate the handwheei counterclockwise, toward you, for
one complete turn, Bring the bobbin thread up by pulling
the needle thread up.
] Pull both threads 4" to 6” {10,0 to 15.0 cm) under and
behind the presser foot..
24