Carl Goldberg GPMA1968 Tiger 60 ARF - Manual (Page 21)

21
3. Locate the exit hole on the rear fuselage side
and remove the covering from over the hole.
SERVO & PUSHROD INSTALLATION
1. Collect the following items:
(2) 5/16” x 19” dowels
(1) 1.5mm x 18” throttle rod
(2) Pushrod connector body
(2) Snap nut
(2) Snap-r-keeper
(3) Radio servos with mounting hardware
(2) Snap link
(2) 1/4” silicone Snap link keepers
(4) 1/2” x 2” heat shrink tubing
(2) 2mm x 8” Pushrod ends unthreaded both ends.
(2) 2mm x 12” Pushrod ends threaded one end
(1) 2mm x 18” Pushrod threaded one end
2. Remove all but one of the servo arms, so that
they look like the above drawing. You will need
two of these.
RADIO INSTALLATION
EXIT HOLE ON SIDE OF FUSE
Remove all of the gray
colored areas
4. Locate the two 5/16” dowels and meas-
ure in 1-1/4” from each end and drill a
5/64” hole. Using your hobby knife or
Moto tool, cut a slot from the hole to the
end of the dowel that the 2mm wire will fit
into.
Locate the two 2mm x 12” rods and
measure 10-1/2” from the threaded end
and make a 90 degree bend. Cut the
bent end off at 3/8”. One will be the
elevator and one will be the rudder
pushrod.
5. Insert the bent end of the pushrod into
the dowel and press into the slot. Apply
CA glue then slide the shrink tubing over
the end allowing it to overhang the end of
the dowel 1/8”. Shrink tight using a heat
gun. If you don’t have a heat gun you can
heat it on your kitchen range. Install one
on each dowel.
Locate the two 2mm x 8” unthreaded
rods and bend a 90 degree angle on one
end 3/8” long. Install these on the other
end of the two dowels in the same man-
ner.