Carl Goldberg GPMA1968 Tiger 60 ARF - Manual (Page 18)

18
ENGINE INSTALLATION
1. In addition to the engine collect the follow-
ing items:
(2) Motor mount
(4) 8-32 blind nut
(4) 8-32 x 1" socket head bolt
(4) #6 x 3/4" sheet metal screw
(4) #8 washer
2. Place the engine on the motor mount, mak-
ing sure that the propeller drive plate is 4-3/4"
away from the firewall.
4. Taking the steering arm, cut off the end of
the arm in the middle of the first hole.
After making sure the holes are aligned,
press the steel collar into the pocket in the
steering arm.
Thread the 6-32 x 3/16" socket head screw
in a few turns until it starts to thread into the
steel collar.
5. Make a 90º bend 1/4" from the end of the
1.5mm x 18” wire.
6. Place the bent end of the wire onto the outer
hole of the steering arm. Secure it with a
snap nut and a drop of CA on the snap nut.
7. Insert the wire into the hole next to the
nosegear block, as shown.
Slide the nosegear wire up into the nosegear
block until the spring coil clears the bottom
of the fuselage when turning.
Tighten the steering arm set screw onto the
nose gear wire. This will be adjusted later,
when the radio is installed.
NOSEGEAR BLOCK
CUT
STEERING ARM
SET SCREW
NOSEGEAR WIRE