Carl Goldberg GPMA1968 Tiger 60 ARF - Manual (Page 2)

2
ITEMS NEEDED TO COMPLETE THIS AIRCRAFT
1 RADIO GUIDANCE SYSTEM (4 CHANNEL
MINIMUM REQUIRED) 5 SERVOS
2 6” AILERON SERVO EXTENSION WIRES
1 Y-HARNESS
1 ENGINE .60-.65 2-CYCLE OR .70-.80 4-
CYCLE, AND MUFFLER
1 ZAP ACCELERATOR
1 2 OZ. BOTTLE ZAP-A-GAP medium CA
1 1/2 OZ. BOTTLE ZAP Super Thin CA
1 BOTTLE ZAP 30 minute and/or 5 minute
epoxy.
1 DuBro Switch mount Part # 203
1 Foam rubber 1/2”x8”x12”
TOOLS AND SUPPLIES FOR ASSEMBLY .
MODELING OR UTILITY KNIFE
WORK SURFACE (24" X70")
ELECTRIC DRILL
1/16”,5/64” 3/32”,1/8", 5/32”, 1/4” DRILL
BITS
SMALL STANDARD & PHILLIPS SCREW-
DRIVERS
MASKING TAPE
NEEDLE NOSE PLIERS
36” RULER OR TAPE MEASURE
FLEXIBLE STRAIGHT-EDGE
T-SQUARE
30-60-90° x 6" TRIANGLE
SOFT PENCIL
A FEW STRAIGHT OR "T" PINS
ADJUSTABLE WRENCH
WIRE CUTTER
OPTIONAL HEAT GUN/COVERING IRON
ACID BRUSH
You can trust ZAP™ CA (cyanoacrylate) and ZAP™ Epoxy to handle all your important
modeling needs. They're designed to withstand the high vibration levels of model air-
craft, but they'll handle just about everything-dollhouse miniatures, model railroads,
arts and crafts, household repairs, building projects, and a variety of industrial applica-
tions.
PROFESSIONAL-GRADE ADHESIVES
NOTE: The TIGER 60 ARF is covered in Flame Red
(#883) and White (#870) UltraCote®.