A&D Weighing GH-252 - Manual (Page 51)

49
Calibration report using an external weight
Key operation
1 Press and hold the
CAL key to display Cal out and release the key.
2 Cal 0 is displayed.
3 When updating the calibration mass value, press the RANGE key and proceed to step 4.
When using preset calibration mass value, proceed to step 5.
4 Specify calibration mass value using the following keys.
RANGE key ........ The key to select the blinking figure
RE-ZERO (+)key .. The key to increase the value of the blinking figure.
MODE (-)key........ The key to decrease the value of the blinking figure.
PRINT key ......... The key to store the new value.
5 When pressing the RE-ZERO key, the zero point is measured and the weight value is
displayed for a few seconds.
6 Place the displayed mass on the pan. Press the PRINT key to measure the mass and the
weight value is displayed for a few seconds.
7 If GLP output is used, glp is displayed and the calibration report is output.
8 The balance returns to weighing mode after this calibration.
Setting of "info 1" Setting of "info 2"
AD-8121 printer format General format
Space, ASCII 20h
Terminator, CR , LF or CR
CR Carriage return, ASCII 0Dh
LF Line feed, ASCII 0Ah
Manufacturer
Model
Serial number
ID number
Date
Time
Calibration type
Calibration weight
Signature
----------- A - & - D
MODEL ----- GH-300
S/N ----- 01234567
ID ------ LAB-0123
DATE -- 2004/07/01
TIME ---- 12:34:56
CALIBRATED(EXT.)
CAL.WEIGHT
---- +200.0000 -- g
SIGNATURE
-
- - - - - - - - - - - - - -