A&D Weighing GH-252 - Manual (Page 12)

10
4. Display Symbols and Key Operation
Display
Key operation
Press and release the key immediately" or "Click the key"........................................
Press and hold the key ................................................................................................
Key When pressed and released When pressed and held
The key to turn the display ON and OFF. The standby indicator is displayed when
the display is turned off. The weighing mode is enabled when the display is turned
on. This key is available anytime. Pressing the key during operation will interrupt
the operation and turn the display OFF.
In the weighing mode, the key to turn the
minimum weighing value ON and OFF.
In the counting or percent mode, the key
to enter the sampling mode.
The key to enter the function table
mode. Refer to "10. Function Table".
The key to switch the preset weighing units
stored in the function table. Refer to "5.
Weighing Units".
The key to perform automatic
response adjustment.
The key to perform calibration using the
internal mass. The key to display other items of the
calibration menu.
The key to outputs the weighing data to a
printer or personal computer (or store it in
memory) depending on the function table
settings. (Factory setting = output)
No function. (factory setting)
By changing the function table:
"Title block" and "End block" for
GLP report are output.
The data memory menu is
displayed.
The key to set the display to zero.
Blinking indicators
Weighing data or
stored data
Units
Standby indicator of
Interval memory function
Response indicator
(Displayed for about 30 seconds
when weighing starts.)
The amount of stored data
with memory data function
Processing indicator
Stabilization indicator
Standby indicator
of power supply
The current
data number
Prior notice indicator of
automatic self calibration
Interval memory,
active indicator