Kistler-Morse KM L-Cell Bolt-On - Manual (Page 5)

Introduction
I-1
Introduction
Welcome
This chapter will describe the organization, manual conventions,
and provide contact and technical service information .
Manual Conventions
Three kinds of special explanations appear throughout the manual —
Warning , Caution and Note. The format and significance of each is
defined below:
WARNING
Possible danger to people. Injury may result if this information is
ignored.
CAUTION
Possible risk to the product. The L-Cell, Microcell, or other equipment
may be damaged if this information is ignored.
Note
Contains additional information about a step or feature critical to the
installation of the L-Cell or the Microcell.
About this manual
This manual describes the installation of the Bolt-On Sensors, L-Cell and
Microcell. The L-Cell is installed on Vertical Legs, Horizontal Beams, and
Skirted Silo applications. The Microcell is installed on Vertical Pipe Leg
applications.
After preparing the Bolt-On Sensor for installation (Chapter 2), go to the
specific application installation chapter and follow the instructions for
installation.
If you have any questions, please contact us at 1-800-426-9010.
The chapters are organized in the following way:
Chapter 1: Description of the Bolt-On Weight Measurement Sensors
Chapter 2: Prepare Bolt-On Sensors for Installation
Chapter 3: Installation of the L-Cell on Vertical Legs
Chapter 4: Installation of the L-Cell on Horizontal Beams
Chapter 5: Installation of the L-Cell on Skirted Silos
Chapter 6: Installation of the Microcell on Vertical Pipe Legs
Appendix A through G include specifications, system calibration, technical
drawings, and troubleshooting charts.