KEYENCE LK-G5000 Series - Manual (Page 13)

13
Settings and Procedures
The following settings should be used as a default.
1. Setting the number of used OUTs
1. Changing OUT settings
(1) Click “Environment Setting”.
(2) Set the number of used OUTs
according to the number of
thickness areas that will be
measured.
Measurement area X 3 = Number
of used OUTs
Ex.) If one thickness area is
measured, then the number of
OUTs that will be used is 3
(3) Click [OK].
(1) Click the “OUT settings” tab.
(2) Configure each of the following
settings.
OUT01: HEAD 01 (Head)
OUT02: HEAD 02 (Head)
OUT03: OUT1 + OUT2
(Calculation between OUT)
* When measuring the thickness of multiple
areas, perform settings as listed below.
OUT04: HEAD 03 (Head)
OUT05: HEAD 04 (Head)
OUT06: OUT4 + OUT5 (Calculation between
OUT)