Hardy HI 2151/30WC Single-Scale Controller - Manual (Page 60)

HI 2151 Series Weight Controller
Profibus Interface Option
54
11 3 57 39
Acceptable number of
averages between 1 and 200
12 4 58 3A
Span weight value, during
calibration, must be positive
13 5 59 3B
Scale capacity value must be
positive (from 1-999,999)
14 6 60 3C
Midpoint linearity value must be
positive
15 7 61 3D
Rate-of-change time units must
be 0, 1 or 2
16 8 62 3E
Rate-of-change time base out
of range
17 10 1 65 41
Analog output not installed
18 2 66 42
Analog output request must be
between 0-4
19 3 67 43
Invalid serial port (RS232)
format request
20 4 68 44
Serial configuration values 0 o1
21 5 69 45
Baud rate request out of range
22 6 70 46
Parity request out of range
(must be 0, 1 or 2)
23 7 71 47
Stop bits must be 0 or 1
24 8 72 48
Word length must be 0 or 1

NOTE: Description in the GSD file was shortened because of 32 character limit.
Unit Diag
Bit #
Diagnostic
Byte
Diagnostic
Bit
Decimal
#
Hex # Description
25 11 1 73 49
Control (Hardware or Software)
must be 0 or 1
26 2 74 4A
Device Address must be
between 0-99
27 3 75 4B Echo request must be 0 or 1
28 4 76 4C
Tare greater than scale
capacity
29 5 77 4D Blind unit option only
30 6 78 4E
Auto zero tolerance must be
between .0001-999,999
31 7 Reserved for future use