COP-USA NVMS 1000 - Manual (Page 31)

28
NVMS-1000 User Manual
for enabling new talk with another device which is launching talk.
5.6.2 Broadcast
① Click “System” on the menu bar of software at the upper right ; choose “Broadcast” to enter the interface.
② Click button to
pop up a window; then check the
devices you want to broadcast, click
【OK】button to save the setting.
③ Click button to stop
broadcast.
5.7 PTZ Control
5.7.1 Parameter Configuration of PTZ
Please confirm the parameter of PTZ has been configured correctly before operating PTZ. Click icon in
display window or “Change Camera Setting” under “Device” to enter the interface. Click “PTZ Setting” to
enable PTZ and setup protocol, baud rate and address of PTZ.
Note: Here the protocol, baud rate and address of PTZ must be consistent with the PTZ decoder.
5.7.2 PTZ control
Return to the live preview interface after configuring parameter of PTZ; select the channel
and click icon or right click to choose “PTZ Control” to open the control panel of
PTZ.
 Click the direction buttons to control its rotational direction; drag the slider to control
its speed.
 Click and buttons to adjust focus, iris and zoom.
 Select a preset point and click to operate this preset point or double click the
preset point to operate it.
 Click
【Cruise】button to list the cruises. Select a cruise and click
button to cruise;
click button to stop cruising.
PTZ can also support track, auto scan, wiper and light function.