Cannon Instrument CMRV-5000 - Manual (Page 28)

22
CANNON ® Mini-Rotary Viscometer CMRV-5000 Instruction & Operation Manual
Version 1.0b—August, 2011; CANNON ® Instrument Company
2139 High Tech Road • State College, PA • 16803 • USA
The Instrument Settings window
4. Use the ID field to input instrument identification information using
up to 30 alphanumeric characters.
The remaining fields in the Instrument Settings window are non-
editable (information is obtained via serial communication with the
CMRV instrument). The Model: field will indicate the model of your
instrument. The S/N: field indicates the serial number from the label
on the Controller rear panel. The Firmware: field indicates the
version for the current instrument firmware. The Port: field indicates
the current communications port for the RS-232 cable connecting
your computer to the CMRV-5000 instrument.
5. When you have entered all settings, click OK.
Checking initial calibration
After you have completed the CMRV instrument calibration for tempera-
ture and cell constants (see following chapters), follow the procedure
below to verify the initial calibration settings.
1. From the VISCPRO primary window, click Configure/MRV/View
Cell Constants. The View Cell Constants window will open.
2. Ensure that Calibration data, including constants and viscosity, is
available for each cell. Then click OK to close the View Cell Con-
stants window.
NOTE Some fields/options are security-protected, and may not be viewable.