Cannon Instrument CMRV-5000 - Manual (Page 11)

5
CANNON ® Mini-Rotary Viscometer CMRV-5000 Instruction & Operation Manual
Version 1.0b—August, 2011; CANNON ® Instrument Company
2139 High Tech Road • State College, PA • 16803 • USA
CHAPTER
2
UNPACKING AND ASSEMBLY
Unpacking the CMRV-5000
CAUTION Some CMRV components are quite heavy. To avoid injury, obtain neces-
sary assistance when lifting and moving shipping cartons and heavier
unpacked components.
 Remove all components from the shipping container(s).
 Remove shipping screws from both fans.
 Remove any and all packing materials (styrofoam, etc.) from the
components.
 Verify reception of shipped materials by comparing equipment items
with packing/parts list(s). Report missing items to CANNON ® Instru-
ment Company immediately.
 Inspect each component for signs for damage. Report damages to the
shipper and to the CANNON ® Instrument Company immediately.
Damaged items Retain all packing materials until the instrument is connected and
functioning properly. If any component(s) must be returned to
CANNON
® Instrument Company, the damaged item(s) should be repack-
aged in the original shipping container. Refer to Chapter 19 of this
manual for instructions on returning defective equipment. Customers
outside the United States should contact the local CANNON
® agent for
procedures on returning products to CANNON ® .
System components
Before beginning assembly, please verify that all components listed on
the packing slip are present, including:
 CMRV-5000 Controller (power supply and controlling electronics)
 CMRV-5000 head unit (thermostated block with heating/cooling units)

Main power cord

Pulley-wheel assembly

5 matched cells/rotors

5 rings and threads

RS-232 interface cable

Small uncalibrated thermometer (0°C to +105°C)

Large calibrated ASTM thermometer (-46°C to +30°C)

3k-ohm temperature probe

CD-ROM with VISCPRO ® software for Windows ® XP ®