Brookfield DV-I Prime - Manual (Page 67)

Brookfield Engineering Laboratories, Inc. Page 67 Manual No. M/07-022-D0613
Appendix I - DVE-50A Probe Clip
Probe Clip DVE-50A is supplied with the DV-I PRIME Optional Temperature Probe. It is used
to attach the RTD temperature probe to the LV/RV Guard Leg or 600 mL low form Griffin beaker.
Figure I-1 is a view of the Probe Clip, showing the hole into which the RTD probe is inserted,
and the slot which fits onto the LV/RV guard leg. When inserting the RTD probe into the Probe
Clip, the upper part of the Clip is compressed by squeezing the points shown in Figure I-1.
RTD Probe
Hole
Squeeze Here when
installing RTD
Temperature Probe
Figure I-1
Figure I-2 shows the Probe Clip (with RTD temperature probe installed) mounted on the guard leg.
Figure I-3 shows the Probe Clip mounted in a 600 mL low form Griffin beaker. This mounting
may be used with LV, RV, HA and HB series instruments.
NOTE:
The RTD probe must be parallel to the beaker wall so as not to interfere with the
viscosity measurement.
Guard Leg
DVE-50A
Probe Clip
RTD Temperature
Probe
Brookfield 600 mL Low Form
Griffin Beaker
DVE–50
Probe Clip
RTD Temperature Probe
Figure I-2 Figure I-3