Brookfield DV-I Prime User Manual

Page 22

Brookfield Engineering Laboratories, Inc.

Page 22

Manual No. M/07-022-D0613

Using the

and

DOWN ARROW

keys, the user enters a value for the minutes portion of

the time to stop. This value can be as high as 99 minutes.

2. When satisfied, the user presses the

ENTER

key again to enter the seconds setting display:

TIMED STOP
SET SEC’S:00

Figure II-18

Using the

and

DOWN ARROW

keys, the user enters a value for the seconds portion of the time

to stop. This value will be between 0 and 59 seconds.

The user presses the

ENTER

key one more time at which point the viscometer will display the

following screen:

TIMED STOP:PRESS
MOTOR ON/OFF

Figure II-19

3. At this point, the user need only press the

MOTOR ON/OFF

key to begin the timed stop

operation.

4. We will assume that the user pressed the

MOTOR ON/OFF

key to ON and is now presented

with the following screen for the duration of the timed run:

CP 123456789
MIN: 15

SEC: 13

Figure II-20

NOTE:

When this mode has begun, a press of the MOTOR ON/OFF key will

interrupt the Timed Stop sequence and return the user to normal operation.

The seconds display will decrement from 59 to zero (0) in one (1) second intervals. When

seconds reaches zero (0), the minutes value will decrement by one (1) minute. This will

continue until all of the time has elapsed at which point the viscometer will display the

following screen:

cP 123456789
TIMED STOP DONE

Figure II-21

At this point, the viscometer will stop the motor and continue to display this screen until

the user presses the

DOWN ARROW

keys to view the Torque and Speed that were

current at the Timed Stop completion. This display would appear as follows: