Panasonic DIGITAL MULTIMEDIA PROJECTOR PT-L501XU - Manual (Page 45)

(Dinstall the lamp unit cover, and
then use a Phillips screwdriver
to securely tighten the lamp
unit cover fixing screws.
NOTE:
• Be sure to install the lamp unit
and the lamp unit cover securely.
If they are not securely installed,
it may cause the protection circuit
to operate so that the power
cannot be turned on.
(D Insert the power cord plug into
the wall outlet and then press
the MAIN POWER switch.
NOTE:
• If the POWER button on the
projector does not illuminate red
when the MAIN POWER switch is
turned on, turn the MAIN POWER
switch off again and check that
the lamp unit and the lamp unit
cover are securely installed. Then
turn the MAIN POWER switch
back on.
©Press the POWER button so
that a picture is projected onto
the screen.
(D Press the MENU button to
display the MAIN MENU
screen, and then press the A
and ▼ buttons to move the
cursor to select “OPTION”.
1
M E N U
3 K E Y S T O N E
P I C T U R E
[irii.] P O S I T I O N
I N D E X W I N D O W
S H U T T E R
/ 3 . A U D I O
A N G U A G E i r a
3 O P T I O N
t s E L G T EEESE N T E R
©Press the ENTER button to
display the OPTION screen,
and then use the A and ▼
buttons to select LAMP TIME.
O P T I O N
P i U T O K E Y S T N
P i U T O R G B
R G B F Q R n f t T
I N P U T D I S P
OFF
< Y ■ P B - P R
m
B f t C K C O L O R
F R O N T / R E f t R
D E S K Y C E I L
P O W E R
BEiDil
< F R O N T
^
D E S K
1 STD
t S E L C T tlEhtl ESC
® Press and hold the ENTER
button on the control panel of
the projector for approximately
3 seconds.
1 O P T I O N
I N P U T D I S P [iVS^^Bo N
ft U T o K E Y S T N FiS3i3Hn N
f=» U T o Y * P B ' P R N
ft U T o RGB IN N
FÍ G B F O R n ft T T y ‘ P B * P R “T
B A C K C O L O R < B L U E
F R O N T / R E A R i F R O N T
D E S K / C E I L I N G i D E S K ►
L f t n PP O W E R ^ S T D
issnsi
F U N C 1 ( I N D E X
I $ S E L C T tESl ESC
The “LAMP TIME’’ will change to
‘TIME RESET [POWER OFF]”.
NOTE:
• This operation will not work if the
ENTER button on the remote
control unit is pressed.
• If the MENU button is pressed,
the lamp time resetting screen
will be cancelled.
©Press and hold the POWER
button for 0.5 seconds or press
it twice to turn off the power.
This will reset the cumulative
usage time for the lamp unit to
zero.
CO
0>
45