Panasonic DIGITAL MULTIMEDIA PROJECTOR PT-L501XU - Manual (Page 36)

O ption settings
Use the A and T buttons on the
projector or remote control unit to
select an item, then press the ◄ or
► buttons to change the setting.
Q P T I O N
F ^ G B F O R n f t T
O F F
< Y - P B ■ P R
B f t C K C O L O R
F R O N T / R E f t R
□ E S K / C E I L I M G
i
F R O N T
L A M P P O t J E R
L f t H P R U N T i r i E
t S E L C T A D J E S C
SCREEN DISPLAY
ON The signal name is
displayed in the top-right
corner of the screen when
the input signal is
changed.
OFF Use this setting when you
do not want the signal
name to be displayed.
AUTO KEYSTN
This should normally be set to ON.
ON
During automatic setup,
the angle of tilt of the
projector is detected and
keystone distortion is
corrected automatically. ,
OFF Use this setting when you
do not want automatic
keystone correction to be
carried out during
automatic setup, such as
when the screen itself is at
an angle.
AUTO Y PB PR
Input
signal
AUTO Y PB PR
ON OFF
HDTV
(1080i)
RGB orYPePR is
selected
automatically
depending on the
synchronising
signal status.
RGB
format
setting
becomes
valid
Other
RGB or YP b P r is
selected automatically
depending on the
synchronising signal
status.
AUTO RGB IN
This should normally be set to ON.
ON During automatic setup,
the projector selects
whichever one of the
RGB1 IN orRGB2 IN
connectors has a signal
being input, and uses that
signal for projection.
(If a picture is being
projected, the signal
source is not automatically
changed.)
OFF Use this setting when you
do not want the signal
source to be changed
automatically during
automatic setup.
RGB FORMAT
I R G B F O R M A ~
r r V - P B - P R M
This setting is only valid when an
HDTV (1080i) signal is being input
and “AUTO Y PB PR” is set to OFF.
36