Cable specifications, Control commands, Ro o – Panasonic DIGITAL MULTIMEDIA PROJECTOR PT-L501XU User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Control commands
The commands which the personal computer can use to control the projector
are shown in the following table.
Command
Control
Contents
Remarks
PON
Power ON
In standby mode, all commands other than
the PON command are ignored.
• The PON command is ignored during
lamp ON control.
• If a PON command is received while the
cooling fan is operating after the lamp
has switched off, the lamp is not turned
back on again straight away, in order to
protect the lamp.
POP
Power OFF
AVL
Volume
Parameter
000-063(Adjustment value 0-63)
IIS
Input signal
selection
Parameter
VID=VIDEO SVD=S-VIDEO
RG1=RGB1(YP
b
P
r
1) RG2=RGB2(YP
b
P
r
2)
ORF
RGB format
selection
Parameter
0=RGB 1=YP
b
P
r
Q$S
Lamp ON
condition query
Parameter
0 = Standby
1 = Lamp ON control active
2 = Lamp ON
3 = Lamp OFF control active
: c
.9.
(0
k .
' 0)
i Q-
0
rO
o
o
. c
1 ni
I >
■O
<
Cable specifications
(When connected to a personal computer)
At the projector
At the computer
(DTE specifications)
NC
NC
NC
NC
NC
NC
NC
NC
39