Panasonic OMNIVISION PV-4661 - Manual (Page 26)

VCRPlus+Progranm
Before you begin, make sure...
□ The clock is set.
O VCR Plus+ Set Up is complete (See pages 24, 25).
Multi Function Display
SPEED
0
)
Use normal Timer Recording steps if:
• the PlusCode for a program is not listed.
■ you anticipate the program, such as a sporting
event, to run over the scheduled stop time.
See page 19 to:
• Cancel a timer recording in progress
• Replace program contents
• Review or Clear program contents once set
Important notes when using a DSS receiver
• When recording programs via a DSS receiver, the
DSS receiver must be left on.
• When recording programs via an antenna or cable,
the DSS receiver must be turned off.
VCR Plus+ and PlusCode are trademarks of
Gemstar Development Corporation.
The VCR Plus+ system is manufactured under
license from Gemstar Development Corporation.
VCR PIUS+
I
Push VCR
Plus+ to display
the VCR Plus+
screen.
ENTER,VCR PLUSCODE
TO END PUSH VCR Plust
Push
the Numbered
Keys
to enter the
PlusCode number.
Refer to your local TV listings.
VCR PKJS+
ENTER VCR PLUSCODE
123456
TO CORRECT PUSH CLEAR
TO ENTER PUSH VCR P1us+
To make corrections
Push the CLEAR button repeatedly to delete the PlusCode
number. Then, enter the correct number.
VCR PIU3+
Push VCR
Plus+ to lock in
your program.
Push
1, 2 or 3
Key to
select the program type.
1 ONETIME
2 OAILV (MON.FRI)
3 WEEKLY
TO SELECT PUSH 1,2 OR Э
TO END PUSH VCR Plus*
To change the recording speed:
Push the SPEED button for SP, LP or SLP.
To cancel program contents:
Push the CLEAR button.
DATE START STOP CH
8SAT 10:30? 12:00? 125
TO CHANGE RECORD SPEED
PUSH SPEED KEY
TO CANCEL PUSH CLEAR
TO END PUSH VCR PIUS+
If you use “A" connection on page 24, the channel shown in
the on-screen display in this step will always be the cable
box output channel number.
VCR P1US+
I
О
Push VCR Plus+
to complete the
program.
If you're using a Cable Box, make
sure that it is tuned to the desired
channel and the power is left on for
timer recording.
TURN VCR OFF
FOR TIMER RECORDING
AND
LEAVE CABLE SOX POWER ON
This display may differ
depending on your
cable box hook-up.
Push VCR
POWER off to
set the timer.
•ШШ-
Multi Function Display
26
For a list of publications that carry the PlusCode numbers in your area, call 1 - 800 - 258 - 4827.
You can obtain unlisted PlusCode numbers by calling 1 - 900 - 454 - 7587. Call costs approximately $.95 per minute.
VCR PlusCodes can not be used to program the VCR to record DSS channels.
Avoid overlapping program times.
An on-screen display wrill indicate if
ai\
invalid PlusCode number has been entered.
An on-screen display will indicate when all timer programs are full.