Panasonic OMNIVISION PV-4661 - Manual (Page 13)

OnScreei^is£la^s_(OSD)
Channel & Function Display
Whenever the channel is
changed, the Channel
number followed will appear
for a few seconds on-screen.
(Some station names may
also appear.)
When a function button is
pushed (PLAY, FF, etc.)
the VCR mode will be
displayed.
08
Menu Screen
Warning and Instruction Displays
These displays will alert you to a missed operation or
provide further instructions.
WNET ---------------
If no active channels are
NO CH FOUND
PLEASE CHECK ANTENNA
found for CHANNEL
CABLE CONNECTION THEN
MEMORY... PUSH VCR CH UP KEY AGAIN
________ >
If you attempt to set or
review a Timer Recording
and the Clock is not set...
PLEASE SET CLOCK
BEFORE programmino
1 Push MENU to display the
menu.
2 Rotate and push the wheel
to make your selection
(see page 10).
MENU
SET UP VCR
SET UP channel
IОI ОМА/ LANGUE: ENGL I SH
SELECT 1 ROTATE WHEEL
SET : PUSH WHEEL
END : PUSH MENU KEY
To get the most from each feature, it is
recommended that you read the Operation
Manual before attempting any operation.
If a Timer Program was not
completed before exiting
the Program mode...
PROGRAM )S INCOMPLETE
VCR Status & Clock Display
After a Timer Program
has been set...
TURN VCR OFF
FOR TIMER RECORDING
Push DISPLAY to display and remove the
overlay shown below.
Rec Time
Remaining
(OTR mode only
see page 16.
Function Status V
Time
REC 12:00AM WNET
0:25 0:00:00
STEREO *■ \ SLP
SAP
MONO
\
Receivable
Broadcast Types
(See page 22.)
Channel &
Call Letter
^ Tape Speed
Counter
Blank Tape and will be Blue Screen
If a blank section of tape is encountered in the Play
mode or the channel you select has no broadcast,
the TV screen will change to a solid blue field.
The screen will remain blue until a recorded signal
is again detected or an active channel is selected.
If you Push REC on the
remote control or REC
and PLAY on the VCR,
and a cassette is inserted
with no record tab...
If you Push PLAY, FF, REW,
or REC on the remote control
or if you push REC and
PLAY, PLAY. FF, REW, or
REC on the VCR without a
cassette inserted...
If you Push POWER or
STOP during a Timer
Recording...
(visible in VCR mode only)
CHECK CASSETTE
RECORD TAB
NO CASSETTE
PLEASE INSERTA CASSETTE
TO CANCEL TIMER REC
PUSH POWER THEN STOP KEY
13