Panasonic OMNIVISION PV-4661 - Manual (Page 18)

Timer Recording
Your VCR can be set up to do a recording
while you are away or otherwise occupied.
Up to 8 programs can be placed in
memory. You can choose to record one
time, daily, or weekly.
I^^^heck list before you begin.
O All connections are made.
(See pages S-S.)
D TV and VCR are plugged in and turned on.
CH VCR/TV selector is sot to “VCR."
O Clock is set to correct time.
□ Record tab in place. (See page 5.)
PROG
Push PROG to display
the program screen.
• If a program is already in
memory, use the Wheel to
select an unused program
number.
RfAl/ START STOP CH|
I
ELECT START DATE
BY ROTATING WHEEL
rPUSH WHEEL->
TO END PUSH PROG KEY
Rotate and push the
WHEEL to select and
set the DATE.
Today's Data
^...WEEiaYiSAT)^— 7 -»g-g,... 31 ...^
Example
\
Wheel Sdectlon Order
VÍEKLY
(MON)
■WEEKLY(aJN)----------- DAILY—6"
Daily and Weekly Timer Recording
If you want the program to be recorded daily
(Mon thru Fri) , enter DAILY in place of the
DATE in step 2. If you want the recording to
be on a weekly basis, enter WEEKLY MON,
TUE, etc..
STOP
-WHEEL
Rotate and push the
WHEEL to select and
set remaining items
at right.
Remaining Items
to be set:
• START time
• STOP time
• CH(annel) number,
or LINE for outside
source recording.
• Speed (SP, LP, SLP).
To Make Corrections
Repeatedly push the Wheel to move forward, or the CLEAR button to
move back to the desired item. Then, select and set continue with step 3.
PROG
Push PROG to end
the program.
• If you want to enter more
programs, select a blank
program number with Wheel
and repeat steps 2 and 3.
P DT STBAT STOP CH SPD
2 ----------------— —
3 ----------—
4 ------------— —
SELECT 1-8¡ROTATE WHEEL
ENTER
CANCEL
END
PUSH WHEEL
PUSH CLEAR KEY
PUSH PROG KEY
___ Push PROG to exit
o this mode.
PROG
Important notes when using a
DSS receiver
• When recording programs via a
DSS receiver, tne DSS receiver
must be left on.
• When recording programs via an
antenna or cable, the DSS receiver
must be turned off.
Push VCR POWER
off to set the timer.
• When recording programs via a
cable box, make sure the cable
box is left on. If the Cable box
cannot be controlled with the
VCR, you must manually select
the desired channel.
TIMER
Multi Function Display
18
If the cassette record tab is missing at the time the VCR power is turned OFF, the tape ejects and
the TIMER indicator flashes.
If the start times of two programs overlap, the lower numbered program will have priority.
If the start time for a timer recording comes up during a normal recording or One Touch Recording (page 16),
the timer recording will not be performed.
If there is a power interruption of more than one minute, the recording may not be performed or continue.
If “PROGRAM IS INCOMPLETE" appears on-screen in step 4, ciieck all entries and make necessary corrections