Panasonic OMNIVISION PV-4661 - Manual (Page 24)

VCR Plus+ Set Up
This setup is for VCR Plus+ and timer
programming only.
In order for your VCR to do a VCR Plus+ recording (see top of page 25 for explanation of VCR Plus+), or a timer recording of
cable stations, some setup is required. At first, find the antenna or cable connection that matches yours. Then, follow the
instructions below your connection.
Choose your Connection Type
(Then, follow the instructions under the diagram.)
[ Connection Type A
if your system iooks iike this diagram, do
the foiiowing.
1. Compiete the “Cabie Box Set Up”
section at right.
2. Skip page 25 and go directiy to page 26
for VCR Pius+ Programming.
Cabie Box Set Up
For connection A (see left) only
MENU
Push MENU to
display the
menu.
Rotate and push
the WHEEL to
select SET UP
CHANNEL
......................... MENU .............................
SET UP VCR
SET CLOCK
SET UP CHANNEL
ID IOMA/LANGUE:ENGL ISH
SELECT
SET
END
ROTATE WHEEL
PUSH WHEEL
PUSH MENU KEY
Rotate and push
the WHEEL to
select CABLE/
DSS BOX SET UP.
--- SET UP CHANNEL ---
ANTENNA SYSTEM ; CATV
VCR PIUS+ CH SET UP
SELECT
SET
END
ROTATE WHEEL
PUSH WHEEL
PUSH MENU KEY
Select YES
if you are
using a cable box and
continue with step 5.
Select NO
if you are not
using a cable box. Then,
Push MENU twice and
turn to page 25.
- CABLE/DSS BOX SET UP -
ARE YOU USING A CABLE
BOX OR DSS RECEIVER?
NO
SELECT : ROTATE WHEEL
SET : PUSH WHEEL
END : PUSH MENU KEY
Rotate and push
the WHEEL to
select your cable
box set up.
* If you selected CABLE/
DSS BOX-»VCR-»TV,
continue with step 6.
If not, Push MENU twice
and turn to page 25.
- CABLE/DSS BOX SET UP -
SELECT YOUR CABLE BOX OR
DSS RECEIVER SET UP.
ABLE/DSS BOX-VCR-TV
VCR-CABLE/DSS BOX-TV
SELECT
SET
END ROTATE WHEEL
PUSH WHEEL
PUSH MENU KEY
Rotate and push
the WHEEL to
change the output
channel number.
■ Number shown is
example only.
You are sure to enter
your cable box output
channel number.
If necessary, refer to your cable box manual.
If you are using Audio/Video jack connection for your cable
box, select and set “VIDEO OUT as the output channel.
- CABLE/DSS BOX SET UP -
ENTER CABLE 80X OR OSS
RECEIVER OUTPUT CHANNEL.
ED
SELECT ROTATE WHEEL
SET PUSH WHEEL
END PUSH MENU KEY
MENU
If your system looks like one of these, do
the following.
1. Skip the “Cable Box Set Up” section at
right and turn to page 25.
2. Complete the “VCR Plus+ Channel Set
Up” section on page 25.
3. Turn to page 26 for VCR Plus+ Programming.
Push MENU to
confirm your
entry.
• This display appears for
five seconds. (Channel
shown is example only)
YOUR VCR IS RECEIVING
THE OUTPUT OF CABLE BOX
OR DSS RECEIVER CH 01
Push MENU twice to return
to the normal screen.
MENU
Then, go directly to VCR Plus+ Programming on page 26.
24