Panasonic OMNIVISION PV-HD1000 - Manual (Page 36)

On-Screen Displays (OSD)
‘Important: If the remote control POWER, ACTION, PROG, CHA/T, INDEX or ADD/DLT button does not work
when pressed, press the VCR button on the remote and try the button again.
Function & Channel Display
When a function button is
pressed, e.g. PLAY, or
you change channels,
a 4 second display
appears first in large
and then small characters.
(Some station names may
also appear.)
Menu Screen
1
Press ACTION* to
display the menu.
2
Press AT and ► to
make your selection.
----------------- MENU -----------------
SET UP VCR
SET UP CHANNEL
SELECT:A T KEY
SET ;► KEY
END
: ACT I ON KEY
To get the most from each feature,
please read the Operating Manual
before attempting any operation.
D-VHS VCR Status & Clock Display
Press DISPLAY to display or remove the
overlay shown below.
Function Current
Status Time
Channel &
Call Letter
Rec Time —
Remaining
(OTR mode only
see page 16.)
REC 12:00AM CH08
■0:25 0:00:00-.
SP
STEREO -4
SAP
MONO
Counter
Broadcast Audio Being
Received (See page 26.)
• This display will disappear
in 5 seconds.
Tape Speed
(See page 34,]
Blank Tape/ No Video Signal Indication
Whenever a blank section of a tape comes up in Play
mode, or when the selected channel has no broad­
cast signal, the TV screen will turn solid blue.
Warning and Instruction Displays
These displays will alert you of a missed operation or
provide further instructions.
If no active channels are found
for CHANNEL MEMORY...
(See page 14.)
If you attempt to set or review
a Timer Recording and the
Clock is not set...
(See page 20.)
After a Timer Program has
been set...
(See page 20.)
If you press REC on the
remote control or D-VHS
VCR, and a cassette is
inserted with no record
tab...
(See pages 16, 34.)
If you press PLAY, FF, REW,
or REC on the remote
control or D-VHS VCR without
a cassette inserted...
(See pages 15, 16.)
If you press POWER or STOP
during a Timer Recording...
(visible in VCR mode only)
(See page 21.)
If you press a function button
other than STOP/EJECT or
POWER on the D-VHS VCR,
or STOP or EJECT or POWER
on the remote control while the
D-VHS VCR is in VCR Lock
mode...
(See page 32.)
If you press POWER, ACTION
or PROG on the remote while
in TV or CABLE/DSS mode...
(See pages 24, 25.)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCR CH UP KEY AGAIN
PLEASE SET CLOCK
BEFORE PROGRAMMING
TURN VCR OFF FOR TIMER
RECORD AND LEAVE
CABLE BOX POWER ON
FOR DTV TIMER RECORDING.
TUNE THE DESIRED CHANNEL
BY DTV SET TOP BOX AND
LEAVE DTV SET TOP BOX ON
CHECK CASSETTE
RECORD TAB
NO CASSETTE
PLEASE INSERT A CASSETTE
TO CANCEL TIMER REC
PUSH POWER THEN STOP KEY
VCR LOCK ACTIVATED
NOW TV/CABLE/DSS MODE
PLEASE PUSH VCR KEY
ON REMOTE
In digital playback mode, some screens shown here may
not be displayed.
36