Panasonic OMNIVISION PV-HD1000 - Manual (Page 13)

If you use a cable box,
tune it to channel 02,
If you use a DSS receiver,
tune it to channel 270.
7
Press ► to continue.
• “NOW TRANSMITTING" appears.
If Cable Box
PLEASE TUNE YOUR CABLE
BOX TO CH02.
If DSS Receiver
PR
EN
PLEASE TUNE YOUR DSS
RECEIVER TO CH 270,
PROCEED:► KEY
END lACTION KEY
8 If Cable Box
IS YOUR CABLE BOX
RECEIVING CH 09 ?
YES
SELEC
SET
El
If DSS Receiver
IS YOUR DSS RECEIVER
RECEIVING CH 2007
YES
(?gl
SELECT:* T KEY
SET :
*■ KEY
END :ACTION KEY
Press AT to select
“YES” or “NO,” and then
press ► to enter.
If you use a cable box and
selected “YES,” go to step 9.
If you use a DSS receiver
and selected “YES,” go to
“Alternate Instructions”
on page 14.
If you selected “NO,” the screen
in step 6 on page 12 will reappear. ____________________
Try entering a different code
assigned to your brand and/ or
repositioning the equipment (see page 11).
If the answer is still “NO,” cable box or DSS receiver
control is not available.
For channel and clock auto set, press ACTION to display
the “SET UP CHANNEL" screen. Then, press AT to select
“AUTO SET." Now, press ► and CH A to start the auto set.
Confirm that your cable box is on
and that your DSS receiver is off.
9
Press AT to select your
local PBS channel number
you receive on your cable
box, and then press ► to
display the “CLOCK AUTO
SET” screen.
PLEASE ENTER YOUR LOCAL
PBS CHANNEL ON CABLE BOX
SELECT
SET
END A T KEY
► KEY
ACTION KEY
10 Press CH A to start Auto
Clock Set.
• If you live near a different time
zone, be sure to enter the PBS
channel in your time zone.
• “AUTO CLOCK SET
PROCEEDING” appears.
CLOCK AUTO SET
CONNECT ANTENNA CABLE
AND IF YOU USE A CABLE
BOX, TUNE IT TO YOUR
LOCAL PBS CH THEN. . .
PLEASE PUSH CH UP KEY
If the Auto Clock Set
displayed time is incorrect...
If you use a cable box and receive
more than one PBS station, try auto
clock set again.
Follow the ‘To Set or Reset the Clock”
section on page 33 and when the
instructions call for you to enter a PBS
station, enter the one you have not
tried yet.
if “AUTO CLOCK SET IS
INCOMPLETE” appears...
The screen below will appear on­
screen if auto clock set data is not
available in your area.
AUTO CLOCK SET
IS INCOMPLETE
PUSH ACTION TO SET CLOCK
Press ACTION to display the “SET
CLOCK" (manual) screen, and
then do steps B and C on page 14.
Note:
If you use a cable box and receive
more than one PBS station, you may
exit the manual clock set screen and
try auto clock set again.
Follow the “To Set or Reset the Clock”
section on page 33 and when the
instructions call for you to enter a PBS
station, enter the one you have not
tried yet.
11 This display appears when
auto clock set is completed.
Confirm that the time is
correct and
press CH A
to exit.
1/ 4/2000 TUE
n-.m
OST:ON
SETTING : CH 02
AUTO CLOCK SET
COMPLETED
'ID : PUSH CH UP KEY
NOTES
Auto clock set will be performed when the D-VHS VCR is turned off the first time each day. If you use a
cable box and you want auto clock set to be performed, the cable box must be left on and tuned to the
PBS channel before the D-VHS VCR power is turned off.
It is necessary to set PBS CHANNEL to perform Auto clock set.
13