Panasonic DVCPRO AJ-D220 P User Manual
Panasonic
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Table of contents
Document Outline
- . Panasonic
- CAUTION
- WARNING:
- Compact size and light weight
- 2-channe1 digital audio with high sound quality
- Up to 123 minutes of playback
- Compatibility with consumer-use equipment
- Time code
- Menu-driven set-up
- Remote control
- RF converter output (CH3, CH4)
- O POWER switch
- 0 Cassette slot
- 0 WIDE lamp
- 0“Consumer-use cassette loaded” display lamp
- ©LOCAUMENU/REMOTE switch
- QAC IN connector
- QSIGNAL GND terminal
- 0 Fan motor
- O Handle
- 0S’VIDEO OUT connector
- 0 VIDEO OUT connector
- O VIDEO MONITOR OUT connector
- Q AUDIO OUT connector
- 0 RF converter output connector
- 0RF converter output selector switch (CH3/CH4)
- Insert the cassette tape.
- Check that the STOP lamp has lighted.
- The unit is set to the stop mode when the STOP button is pressed.
- Insert the cassette tape.
- Press the PLAY button.
- j To stop playback, press the STOP button.
- Keep pressing the FF or REW button during playback.
- Normal playback is restored when the button is released.
- Press the PAUSE/STILL button during playback.
- The tape is advanced or reversed frame by frame when the FF or REW button is pressed during still-picture playback. •
- Setting the BEGIN and END points [Menu mode]
- Set the VTR to the menu mode.
- 2 Select the “BGN/END PRESET” set-up menu item, and press the MODE (REW) button. (See page 21)
- 2 Select TC or CTL using the COUNTER button.
- 4 Select either BGN or END using either the BEGIN button or the END button.
- Select the digit (fiashing display) in which the change is to be made using the UP (FF) and DOWN (STOP) buttons.
- Press the DATA4- (PAUSE/STILL) button or DATA- (PLAY) button to change the value.
- Upon completion of the settings, press the SET button.
- The settings are now stored in the memory, and the display returns to the regular menu screen.
- Setting the BEGIN and END points [Front panel]
- Displaying the BEGIN and END points
- Setting the repeat playback mode
- 1 Set the VTR to the menu mode.
- ^ Select the “MEMORY MODE” set-up menu item, and select the repeat playback mode. (See page 21)
- Set the VTR to the STOP mode.
- Set to TC or UB using the COUNTER button.
- J Press the PLAY button.
- The display changes as shown below.
- Characters displayed
- Display position
- Operating mode
- Set the VTR to the menu mode.
- Select the item to be set using the UP (FF) and DOWN (STOP) buttons. The cursor on the menu screen moves and selects the item.
- Press the DATA+ (PAUSE/STILL) button or DATA- (PLAY) button to change the setting.
- Upon completion of the setting, press the SET button.
- SETUP-MENU INIT. SET OK? (PUSH SET KEY)
- Checking the hour meter