Panasonic OMNIVISION PV-HD1000 - Manual (Page 14)

One Time D-VHS VCR Setup
(continued)
•Important: If the remote control POWER, ACTION, PROG, CHA/V, INDEX or ADD/DLT button does not
work when pressed, press the VCR button on the remote and try the button again.
Alternate Instructions
Complete the following steps if, any of the following applies:
• You selected “NO” in step 3 on page 12.
• You selected “VCR^CABLE/ DSS BOX^TV” in step 4
on page 12.
• You selected “NO REMOTE” in step 6 on page 12
(your cable box or DSS receiver is not remote
controllable).
• You use a DSS receiver and selected “YES” in step 8
on page 13.
1
Turn on the cable box and
set it to the local PBS channel.
• If you live near a different time
zone, make sure to set the
channel in your time zone.
• If you use a DSS receiver,
it must be turned off.
SELECT/SET
►) keys
B
CHANNEL/CLOCK AUTO SET
CONNECT ANTENNA CABLE
AND IF YOU USE A CABLE
BOX, TUNE I T TO YOUR
LOCAL PBS CH THEN. . .
PLEASE PUSH CH UP KEY
Press CH A* to start Channel Auto Set and
Auto Clock Set.
• The follovYing messages appear.
“CH AUTO SET PROCEEDING”
“AUTO CLOCK SET PROCEEDING”
This screen appears to confirm that
auto clock set is completed.
3
Confirm that the time is
correct and press CH A
to exit.
If this screen appears, auto
clock set is not available in
your area. Please set the clock
manually as described below.
1/ 4/2000 TUE12:
DST:ON
SETTING : CH 02
AUTO CLOCK SET
COMPLETED
MD : PUSH CH UP KEY
AUTO CLOCK SET
IS INCOMPLETE
PUSH ACTION TO SET CLOCK
A Press ACTION to display the
SET CLOCK screen.
B Press AT and ◄ ► to
select and set the month,
date, year, time, and
DST. (Daylight Saving Time).
To Make Corrections,
repeatedly press ► to move the cursor
to the incorrect entry and make the correction.
-\4 y — SET CLOCK-----------
/(X DST;ON
SELECT;* » KEY
SET ;► KEY
END : ACT! ON KEY
C Press ACTION twice to start
the clock and exit this mode.
11 412000 TUE 12:
SET ► KEY
START : ACT I ON KEY
If the displayed time and DST.
are not correct...
If you happen to live close to two time zones,
the D-VHS VCR may have recognized the
PBS channel (setting channel) in the wrong
time zone. Please do the following to correct
the situation.
a Make a note of the SETT1NG:CH number
shown on screen and press CH A to exit.
b Delete the setting channel from the D-VHS
VCR channel memory. (See the ‘To Add or
Delete a Channel’’ section on page 33.)
c Press ACTION to display the menu.
d Press AT to select “SET CLOCK," and then
press ► to display the “SET CLOCK” screen,
e Press AT and ► to select and set “AUTO
CLOCK SET.”
f Follow the One Time D-VHS VCR Setup
instructions on pages 12 ~ 14,
• If you use a cable box and have multiple PBS
stations, tune the cable box to a different PBS
station and try auto clock set using the menu.
14