Panasonic PV-4760 - Manual (Page 39)

PV-4760
CHANNEL MEMORY
CHANNEL CHART
• CATV modes [NOR, HRC, IRC]
CHANNEL
DESIGNATIONS
CATV CHANNEL
RECEIVED
FROM CABLE
CHANNEL SELECTION
& INDICA^ON
ON VCR
BROADCAST VHF 2 - 1 3 0 2 - 1 3
CATVMID/SUPER BANDS A ~ W 1 4 - 3 6
CATV HYPER BAND a a ~ e e e 3 7 - 6 4
CATV LOW BAND A - 5 ~ A - 1 9 5 - 9 9
SPECIAL CATV CHANNEL 5A (between 4 & 5) 01 (HRC, IRC only)
ULTRA BAND* 65 - 94 6 5 - 9 4
* If you receive UHF Band Itirough a CATV system, a UHFA^HF splitter and a flat
“TWIN LEAD" cable may be necessary for proper reception.
• TV mode
CHANNEL
DESIGNATIONS
CHANNEL
RECEIVED
OFF THE AIR
CHANNEL SELECTION
& INDICATION
ON VCR
VHF 2 - 1 3 0 2 - 1 3
UHF 1 4 - 6 9 1 4 - 6 9
К О Т Е :
• CATV channel designations are not standardized like broadcast channels. Therefore, there may be some
variation between cable systems. If in doubt, consult your cable company or local Panasonic Dealer,
• Numbers not listed on the charts above cannot be entered.
• Please note that all previously erased channels may return to original selections when the position of the
ANTENNA SYSTEM SELECT Button is changed while CHANNEL MEMORY Button is ON.
• When the power is disconnected for long periods and electric back-up system shuts off, it is possible that
CHANNEL MEMORY may return to original manufactured selections.
In this case reset CHANNEL MEMORY as desired.
HOW TO DETERMINE YOUR TYPE OF CABLE SYSTEM
® Set the ANTENNA SYSTEM SELECT Button to the “CATV” position.
© Select various channels that you normally receive on your cable system. The channels should lock in almost
immediately after they are selected and should appear perfectly tuned.
The synthesized tuner on this model will automatically fine tune the selected channel for you. If the channels
seem to take some time to lock in or will not lock in, you may have the HRC or IRC cable systems. In this
case, continue with steps and (D below.
© Set the button to the “HRC" position and try the above procedure again.
© If you are having trouble with only channels 5 and
6 . you may have an “IRC" type system so set the button
to the "IRC” position. When the proper setting is determined you should be able to clearly receive all the
cable channels that you were originally able to receive on your TV.
NOTE:;
• If you cannot determine your cable system, please contact your cable company.
U3ING YQI;R tapes *:.R ViOFO REr-Ono.:n IN
Tapes made i.n VIHEO RbCOFiDERS sold ni the L M i t e d ;an only be oacK on VCF( umis whicn
use the NTSC television system and have matching tai e speeds. You can onlv use your VCR in another country
whici’ has a leleviston system designed for standard U.S. Television channel frequencies. VHS VIDEO Recorde. s
produced for the Lfnited States conform to the NTSC television system.
- 3 8 -