Yamaha HTR-6080 - Manual (Page 99)

Troubleshooting
Problem Cause Remedy
See
page
The sound suddenly
goes oft. The protection circuitry has been activated Check that the speaker impedance setting is correct. 25. 9]
because o1 a short circuit, etc.
Check that the speaker wires are not touching each
other and then turn this unit back on.
The sleep tinter has turned this unit off. Turn this unit on. and play the source again.
The sound is muted. Press (J) MUTE orQ)VOLUME +/-"011 the remote
control to resume audio output.
40
Sound is heard from
the speaker on one
side only.
Incorrect cable connections. Connect the cables properly. If the problem persists,
the cables may be defective. i3
Incorrect settings in "SPIZAKER
LEVEL”. Adjust the "SPEAKER LEVEL” settings. 74
Only the center
speaker outputs
substantial sound. When playing a monaural source with a
CINEMA DSP program, the source signal
is directed to the center channel, and the
front and surround speakers output eifect
sounds.
No sound is heard
from the center
speaker.
"CENTER SP” in "SET MENU" is set to
"NONE". Set "CENTER SP” to “SML” or "ERG”. 73
One of the Hi.Fi DSP programs (except for
’Tch Stereo”) has been selected. Try another sound field program. 42
No sound is heard
from the presence
speakers.
The sound field prognims are turned off. Press ©STRAIGHT to turn them on. 47
You are using a source or program
combination that does not output sound
from all channels. Try another sound I’ield program. 37
“EXTRA SP ASSIGN" is set to a setting
other than "PRESENCE”. " Set “EXTRA SP ASSIGN” to "PRESENCE”. 72
No sound is heard
from the surround
speakers.
"SUR. L/R SP” in "SET MENU” is set to
"NONE”. Set “SUR. L/R SP” to “SML” or "ERG”. 73
This unit is in the “STRAIGHT” mode
and a monaural source is being played
back. Press ©STRAIGHT on the front panel so that
“STRAIGHT” disappears from the Iront panel
display.
47
No sound is heard
from the surround
back speakers.
"SUR. L/R SP” in "SET MENU” is set to
"NONE” and “SUR.B L/R SP” is
automatically set to "NONE”. Set "SUR. L/R SP” and “SUR.B L/R SP" to a setting
other than "NONE”. 73
-SUR.B L/R SP” in ”SLT MENU” is set
to "NONE". Set -SUR.B L/R SP” to a setting other than "NONE”. 73
FRONT B speakers
cannot be activated. "EXTRA SP ASSIGN” is set to a setting
other than "ERONT B”. Set “EXTRA SP ASSIGN” to “ERONT B”. 72
No sound from the
center, surround or
surround back
speakers when the
FRONT B speakers
are activated. "ERONT B” in “SPEAKER SET’ is set to
"ZONE B”. Set "FRONT B” to "i-RONT”. 72
Presence speaker
settings are not
available in "SET
MENU”. -EXTRA SP ASSIGN” is set to a setting
other than "PRESENCE". Set -EXTRA SP ASSIGN” to "PRESENCE”. 72
95
En