Yamaha HTR-6080 - Manual (Page 10)

Quick start guide
Step 1: Set up your speakers
Place your speakers in the room and connect them to this
unit.
1
Place your speakers and subwoofer in the
room.
2
Connect speaker cables to each speaker.
4.
O* o
Be sure to connect the (red) and ’ ( b l a c k ) properly.
Cables are colored or shaped differently, perhaps with a
stripe, groove or ridge. Conned the striped (grooved, etc.)
cable to the “+” (red) terminals of this unit and your speaker.
Connect the plain cable to the (black) terminals.
Connect each speaker cable to the
corresponding speaker terminal of this unit.
(Jy .Make sure that this unit and the subwoofer are
unplugged from the AC wall outlets.
(
2
)
Twist the exposed wires of the speaker cables
together to prevent short circuits.
Do not let the bare speaker wires touch each other.
(4) Do not let the bare speaker wires touch any metal
part of this unit.
Be sure to connect the left channel (L), right channel
(R), “+” (red) and (black) properly.
Front speakers and center speaker
> * ' • ?.. * #
II II To the center speaker
*
.. To the front left
Front right speaker speaker
Surround and surround back speakers
To the surrount|_
right speaker
/ \ '
To the surround
•..back left
speaker
To the surround To the surround
left speaker back right speaker
5
Connect the subwoofer cabie to the
SUBWOOFER PRE OUT jack of this unit and
the input jack of the subwoofer.
Input jack
SUBWOOFER PRE OUT jack
6
En