Yamaha HTR-6080 - Manual (Page 55)

FM/AM tuning
Automatic preset tuning
You can use the automatic preset tuning feature to store up
to 40 FM stations with strong signals (A1 to E8: 8 preset
station numbers in each of the 5 preset station groups) in
order. You can then recall any preset station easily by
selecting the preset station number.
1
Rotate the ©INPUT selector on the front
panel to select “TUNER” as the input source.
Notes
•
Any Stored -Station data existing under a preset station number is
cleared when you store a new station under the stime preset
station number.
• If the number of received stations does not reach 40 {E8),
automatic preset tuning automatically stops after searching for
all the available stations.
• Only FM stations with sufficient signal -strength are stored
automatically by automatic preset tuning. If the station you
want to store is weak in signal strength, tunc into it manually
and store it as described in “Manual preset tuning’' below.
2
Press (DFIM/AM to select “FM” as the
reception band.
“FM” appears in the front panel display.
3
Press and hold ©MEMORY for more than 3
seconds.
The preset station number as well as the MEMORY
and AUTO indicators flashes. After approximately 5
seconds, automatic presetting starts from the current
frequency and proceeds toward higher frequencies.
Flashes
___________________________ ^
Manual preset tuning
,i4!.,)F41 38. ril-lz
Flashes
When automatic preset tuning is completed, the front
panel display shows the frequency of the last preset
station.
'W
You can specify the preset number from which this unit stores
FM stations. Press ©A/B/C/D/E and then ©PRESET/
TUNING/CH <3/0 repeatedly after you perform step 3 to
select the pre-set sttition number under which the first station
will be stored.
' You can begin tuning towvird low'cr frequencies to store FM
stations automatically. Press ©PRESET/TUNING so that the
colon (:) disappears from the front, panel display and then press
(D PRESET/TUNING/CH <3 after pressing and holding
©MEMORY for more than 3 seconds.
You can also store up to 40 stations (A1 to E8: 8 preset
station numbers in each of the 5 preset station groups)
manually.
1
Tune into a station.
See page 50 for tuning instructions.
2
Press © MEMORY on the front panel.
The MEMORY indicator flashes in the front panel
display for approximately lO seconds.
MEMORY
Flashes
Press ©A/B/C/D/E repeatedly to select a
preset station group (A to E) while the
MEMORY indicator is flashing.
The selected preset station group letter appears.
Check that the colon (;) appears in the front panel
display.
Flashes
- 4 4
MU::
Preset station Colon (:)
group
51
En