Yamaha HTR-6080 - Manual (Page 56)

FM/AM tuning
Press ©PRESET/TUNING/CH <1 /t> to
select a preset station number (1 to 8) while
the MEMORY indicator is flashing.
• Press d)C> to select a higher preset station number.
• Press dX] to select a lower preset station number.
Flashes
Press ©PRESET/TUNING/CH <]/>onthe
front panel (or ® PRESET/CH A / V on the
remote control) to select the desired preset
station number (1 to 8).
The preset station group and number appear in the
front panel display along with the station band and
frequency.
Preset station number
Press ©MEMORY while the MEMORY
indicator is flashing.
The station band and frequency appear in the front
panel display with the preset station group and
number you have selected. The MEMORY indicator
disappears from the front panel display.
I ! ■! :: ¡••■s
I -M” f" T =
The displayed station has been stored as At.
Notes
* Any stored station data existing under a preset station
number is cleared when you store a new station under the
same preset station number.
• The reception mode (stereo or monaural) is stored along
with the station frequency.
Selecting preset stations
You can tune into any desired station simply by selecting
the preset station group and number under which it w'as
stored.
When performing this operation with the remote control, .set the
operation mode selector to ©SOURCE and then press TUNER
to select ’TUNER” as the input source.
1
Press ©A/B/C/D/E (or press ®A-E/CAT. o / >)
to select the desired preset station group (A to
E).
The preset station group letter appears in the front
panel display and changes each time you press the
button.
Exchanging preset stations
You can exchange the assignments of two preset stations
with each other. The example below describes the
procedure to exchange preset station “El” with “A5”.
1
Select preset station “E1 ” using ©A/B/C/D/E
and ©PRESET/TUNING/CH O/O on the
front panel.
See “Selecting preset stations” on the left column.
2
Press and hold ©EDIT for more than 3
seconds.
“El” and the MEMORY indicator flash in the front
panel display.
Flashes
_£1J Fl'i 3 3 . 9 r'lHz
Flashes
Select preset station “A5” using ©A/B/C/D/E
and ©PRESET/TUNING/CH .
“A5” and the MEMORY indicator flash in the front
panel display.
See “Selecting preset stations” on the left column.
Flashes
F-P1 MHz
Flashes
4
Press ©EDIT again.
“EDIT E1-A5” appears in the front panel display and
the assignments of the two preset stations are
exchanged.
52
En