Yamaha HTR-6080 - Manual (Page 20)

Connections
Information on HDIVII™
I HDMI compatibility with this unit
Audio signal
types
Audio signal
formats
Compatible
HDMl
components
2ch Linear PCM 2eh, 32-192 kHz,
16/20/24 bit
CD, DVD-Video,
DVD-Audio, etc.
Multi-ch Linear
PCM
8ch, 32-192 kHz,
16/20/24 bit
DVD-Audio, etc.
DSD 2/5.1 eh,
2.8224 MHz, I bit
SACD, etc.
Bitstream Dolby Digital, DTS DVD-Video, etc.
This unit’s HDMl interface is based on the following
standards:
• HDMl Version 1,2a (High-Definition Multimedia
interface Specification Version 1.2a) licensed by
HDMl Licensing, LLC.
• HDCP Revision 1.1 (High-bandwidth Digital
Content Protection System Revision 1.1) licensed
by Digital Content Protection, LLC.
Notes ;
■ When CPPM copy-protected DVD audio is played back, video
and audio signals may not be otitptit depending on the type of
the DVD player.
■ This unit is not compatible with HDCP-incompatible HDMl or
DVl components.
• You can check the potential problem about the HDMl
connection (.see page 41).
HDMl jack and cable plug
• We recommend that you use an HDM! cable shorter than 5
nteters (16 feet) with the HDMl logo primed on it.
• Use a conversion cable (HDMl jack ■O- DVl-D jack) to connect
this un.il to other DVI components.
Notes
■ Do not diseonneet or connect the cable or turn off the power of
the HDMl ctmiponents eonnecled to the HDMl OUT jack of
this unitwhile data is being transferred. Doing so may disrupt
playback or cause noise.
• Audio signals input at input jacks other than the HDMl IN I or
HDMl IN 2 jack of this unit cannot he digitally output at the
HDMl OUT jack.
■ If you turn off the posver of the video monitor connected to the
HDMl OUT jack via a DVI connection, this unit may fail to
establish the connection to the eomponent.
■ The analog video signals input at the composite video, S-video
and eomponeiit video jacks can be digitally up-converted to be
output at the HDMl OUl’jack. Set “VIDEO CONV.” to “ON"
in “MANUAL SE'l’UP" (see page 81) to activate this feature.
16 Ert