Sounds center geo (center graphic equalizer), Note, Sounds hp tone ctrl – Yamaha HTR-5830 User Manual

Page 48: Headphone tone control), Input 1 1/0 assign (input/ output assignment), For component video jacks a (iheh] ) and b, For optical input jacks 1 (1b< 1)) and 2, For coaxial input jack 3 {1c<3)), Notes, Input2 inputmode

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SET MENU

SOUNDS CENTER GEO (center

graphic equalizer)

Use this feature to adjust the built-in 5-band graphic

equalizer so that the center speaker tonal quality matches

that of the left and right front speakers. You can select the

100 Hz, 300 Hz, 1 kHz, 3 kHz, or 10 kHz frequencies.

Control range (dB): -6 to +6

Initial setting: 0 dB for 5-band

Press \/ to select a higher frequency and /\

to select a lower frequency.

Press < / > to adjust the level of that

frequency.

Note

• You can monitor the center speaker sound while adjusting this

partuneter by using the test tone. Press TEST before starting
the foregoing procedure. Once you begin this procedure, the
test tone remains at the center speaker and you cait hear how
the sound changes as you adjust the various frequency levels.
To stop the test tone, press TEST,

SOUNDS HP TONE CTRL

(headphone tone control)

Use this feature to adjust the level of the bass atid treble
when you are using headphones.

Control range (dB);

HP BASS...................... -6 to +3
HP TRBL (treble).........-6 to+3

Initial setting:

HP BASS...................... 0 dB
HP TRBL .....................OdB

INPUT 1 1/0 ASSIGN (input/

output assignment)

You can assign jacks according to the component to be
used if this unit’s initial settings do not correspond to
your needs. Change the followdng parameters to reassign
the respective jacks and effectively connect more
components. Once the inputs have been reassigned, you
can select the corresponding component by using INPUT
<] / O on the front panel or the input selector buttons on
the remote control.

For COMPONENT VIDEO jacks A ( I

] ) and B

( I H E B I )

Choices:

|A1 VCR.V-AUX, DTV/CBL.

DVD

|B1 VCR, V-AUX,

DTV/CBL,

DVD

For OPTICAL INPUT jacks 1 (1B< 1)) and 2

( 1 B < 2 ) )

Choices:

(1) VCR, V-AUX, DTV/CBL,

DVD,

MD/CD-R, CD

(2) VCR, V-AUX,

DTV/CBL,

DVD,

MD/CD-R, CD

For COAXIAL INPUT jack 3 { 1 C < 3 ) )

Choices:

VCR, V-AUX, DTV/CBL, DVD,

MD/CD-R,

Notes

• You cannot select a specific item more than once for the same

type of jack.

• When you connect a component to both the COAXIAL and

OPTICAL jacks, priority is given to the input signals from the
COAXIAL jack,

INPUT2 INPUTMODE

(initial input mode)

Use this feature to designate the input mode for sources
connected to the DIGITAL INPUT jacks when you turn
on this unit (see page 26 for details about the input
mode).

Choices:

AUTO,

LAST

AUTO

Select this setting to allow the unit to automatically detect
the type of input signal and select the appropriate input
mode.

LAST

Select this setting to set this unit to automatically select
the last input mode used for the respective sources.