Connecting the am loop antenna, Orient the am loop antenna for the best reception, Notes – Yamaha HTR-5830 User Manual

Page 17: Connecting the antennas

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Connecting the antennas

CONNECTIONS

Both AM and FM indoor antennas are inclttded with this

unit. In general, these antennas should provide sufficient

signal strength.

Connect each antenna correctly to the designated
terminals.

Indoor FM

antenna

(included)

Ground {GND terminal)

For maximum safety and minimum
interference, connect the antenna GND

temiinal to it good earth ground. A good
earth ground is a metal stake driven into
moist earth.

■ Connecting the AM loop antenna

Set up the AM loop antenna, then connect it

to the terminals on this unit.

Press and hold the tab to insert the AM loop

antenna lead wires into the AM ANT and
GND terminals.

Orient the AM loop antenna for the best

reception.

Notes

• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always he connected, even if an

outdoor AM antenna is connected to this unit.

• A properly installed outdoor antemia provides clearer

reception than an indoor one. If you experience poor reception
quality, an outdoor antenna may improve the quality. Consult
the nearest authorized YAMAHA dealer or sendee center
about the outdoor antennas.