Yamaha HTR-5830 - Manual (Page 23)

CONNECTIONS
IMPEDANCE SELECTOR switch
(U.S.A. and Canada models only)
CAUTION
Do not change tlie setting of the IMPEDANCE
SELECTOR switch when the unit power is switched on,
as doing so may damage the unit.
If this unit fails to turn on when STANDBY/ON is
pressed on either the front panel or remote control, the
IMPEDANCE SELECTOR switch may not be fully slid
to either position. If this is the case, slide the switch all
the way to either position when this unit is in standby
mode.
Select the switch position (upper or lower) according to
the impedance of the speakers in your system.
(U.S.A. model)
irssi:|
IMPEDANCE SELECTOR switch
Swatch position Speaker Impedance level
Upper FRONT A OR B The impedance of each speaker must be 6 Q or higher.
CENTER. SURROUND The impedance of each speaker must be 6 Q or higher.
Lowfer FRONT A ORB The impedance of each speaker must be 8 Q or higher.
CENTER, SURROUND The impedance of each speaker must be 8 Q or higher.
19