Yamaha HTR-5830 - Manual (Page 13)

CONNECTIONS
Before connecting components
CAUTION
Do not connect this unit or other coinponents to the
mains power until all connections between the
components have been completed.
Be sure to connect the left channel (L), right channel
(R), "+” (red) and (black) properly. Some
components require different connection methods and
have different jack names. Refer to the operation
instructions for each component you wish to connect to
this unit.
After you have completed all connections, check them
again to make sure they are correct.
The jack names correspond to the names on the input
selector.
■ Connecting to digital jacks
This unit has digital jacks for direct transmission of
digital signals through either a. coaxial or fiber optic
cable. You can use the digital jacks to input PCM, Dolby
Digital and DTS bitstreams. Use digital connections if
you wish to enjoy the multi-channel sound track of DVD
material, etc. with DSP effects. Both digital input jacks
are acceptable for 96 kHz sampling digital signals.
Note
• The OPTICAL jack on this unit conform to the EIA standard.
If you use a fiber optic cable that does not conform to EIA
standard, this unit may not function properly.
DIGITAL INPUT Jacks
Audio component jacks |
(page 12) j
SUBWOOFER OUTPUT
Jack (page 16)
' _ Antenna input terminals
i (page 13)
This Jack is reserved for factory use.
Do not connect any equipment to this Jack.