Sound 2 sp distance, Speaker distance), 1 press/\/\/to select “unit – Yamaha HTR-5830 User Manual

Page 47: 3 press /\ / nv to select a speaker, 4 press < / > to set the distance, Sounds lee level, 1 press /\ / w to select the item to be adjusted, 2 press < to adjust the lfe level, Note, Sdund 4 d. range

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SETMENU

SOUND 2 SP DISTANCE

(speaker distance)

Use this feature to manuall}' input tlie distance of each

speaker and adjust the delay applied to respective

channel. Itleally, each speaker should be the same
distance from the main listening position. However, this is
not possible in most home situations. Thus, a certain
amount of delay must be applied to the sound from each

speaker so that all sound will arrive at the listening

position at the same time.

P r e s s / \ / \ / t o select “UNIT”.

Press < / > to select the unit “meters” or

“feet” to be used in setting.

Press /\

Nv to select a speaker.

Press

< / >

to set the distance.

Press > for higher values and < for low'er values.

SOUNDS LEE LEVEL

I Ue to adjust the output level of the LFE (low'-frequency

effect) channel according to the capacity of your
subwoofer or headphones. The LFE channel carries low-
frequency special effects which are only added to certain
scenes. This setting is effective only when this unit
decodes Dolby Digital or DTS signals.

Control range:

SP LFE"(Speaker)...............-20 to 0 dB
HP LFE (Headphone)......... -20 to 0 dB

Initial setting: 0 dB

Press /\ / w to select the item to be

adjusted.

Press < to adjust the LFE level.

Note

• Adjust the LFE level according to the capacity of your

subw'oofer or headphones.

SDUND 4 D. RANGE

(dynamic range)

Use this feature to adjust the dynamic range. This setting
is effective only wdien the unit is decoding Dolby Digital
signals.

Choices:

MAX

(maximum), STD (standard),

MIN (minimum)

MAX

Select MAX for feature films.

■ Setting by “meters”

Control range:

0.30 to 24.00 m (for front L/R, center,

surround L/R)

Initial settings; 3.00 m (for front L/R, center,

surround L/R)

■ Setting by “feet”

Control range:

1.0 to 80,0 ft (for front L/R, center,

surround L/R)

Initial settings:

10.0 ft (for front L/R, center,

surround L/R)

Note

• No delay wHI be set if you set the same distance for the front

L/R and center, or the surround L/R,

STD

Select STD for general use.

MIN

Select MIN for listening to sources at lowf volume levels.