Yamaha HTR-5830 - Manual (Page 33)

PLAYBACK
m Virtual CINEMA DSP
With Virtual CINEMA DSP, you can enjoy all sound field
programs without surround speakers. It creates virtual
speakers to reproduce a natural sound field.
You can listen to virtual CINEMA DSP by setting "1C
SURR" in the set menu to NON. Sound field processing
changes to Virtual CINEMA DSP automatically.
Note
• Virtual CINEMA DSP tvill not activate, even when 1C SURR
is set to “NONE" (see page 42) in the foliowing cases:
- When the 5ch Stereo, DOLBY DIGITAL, Pro Logic, Pro
Logic il, or DTS program is selected.
- When the sound effect is turned off.
- When 6CH INPUT is selected as the input source.
- When a digital signal witlt a sampling frequency greater
than 48 kHz is input to this utiit.
- When using tile test tone.
- When connecting the headphones,
■ To listen with headphones
(SILENT CINEMA)
The SILENT CINEMA mode allows you to enjoy multi­
channel music or movie sound, including Dolby Digital
and DTS surround, through ordinary headphones.
SILENT CINEMA activates automatically whenever you
connect headphones to the PHONES jack while listening
to CINEMA DSP or HiFi DSP sound field programs. The
“SILENT CINEMA” indicator lights up on the front
panel display, (If the sound field programs are off, you
listen with normal stereo reproduction.)
Notes
• This feature is not available when 6CH INPUT is selected or
the unit is receiving a digital signal wdth a sampling frequency
greater than 48 kHz.
• The sound from the LFE channel will he mixed and output
from the headphones.
■ Normal stereo reproduction
Press STEREO to turn off the sound effect
for norma! stereo reproduction.
Press STEREO again to turn the sound effect back
STEREO
( enter )
Notes
• If you turn off the sound effects, no sound is output from the
center speaker or surround spetikers.
• If you turn off the sound effects wdiile the unit is reproducing
sound from a Dolby Digital or DTS signal, the dynamic range
of the signal is automatically compressed and the unit will mix
the sounds of the center and surround speaker channels and
output tltem from the front speakers.
• The volume may be greatly reduced wiren you turn off the
sound effects or if you set “SOUND 4 D. RANGE (dyiumiic
range)” on the set menu to MIN. In this case turn on the sound
effect,
\ • /
• During stereo reproduction, you can display information such
as the type, format and sampling frequency of the signal input
from the components coniiecfed to this unit.
(While playing a source)
1 Press AMP.
2 Press /\ / \T to display the information about
the input signal.
(Format): Tlie display shows the signal format. When the
unit cannot detect a digital signal it
automatically sw'itches to analog input,
in: The display shows the number of input signal
source channels, as follows: For multi-channel
soundtrack such as front 3 channels, surround 2
channels and LFE, the display show's “3/2/
LFE”.
fs: The display show's the sampling frequency.
When the unit is unable to detect the sampling
frequency “Unknow-n” show's in the front panel
display.
rate: The display show's the bit rate. When the unit is
unable to detect the bit rate "Unknow'n” show's
in the front panel display,
fig; The display show's the flag - data encoded in a
DTS or Dolby Digital signal that causes this
unit to automatically switch to the appropritite
decoder for playback.
Front panel Remote control
29