Yamaha HTR-5830 - Manual (Page 21)

CONNECTIONS
Front A speaker
Right Lett
Surround speaker
Right Left
FRONT SPEAKERS terminals
You can connect up to two speaker systems to these
terminals. When using only one speaker system, connect
it to either of the FRONT A or the FRONT B terminals.
SURROUND SPEAKERS terminals
A surround speaker system can be cotmected to these
terminals.
CENTER SPEAKER terminals
A center speaker can be connected to these terminals.
The diagram shows the speaker layout in the listening
room.
SUBWOOFER jack
When using a subwoofer with built-in amplifier, including the YAMAHA Active Servo Processing Subw'oofer System,
connect the input jack of the subwoofer system to this jack. This unit will direct low bass signals distributed from the
front, center and/or surround channels to this jack in accordance wdth your SPEAKER SET selections. The LEE (low-
frequency effect) signals generated wdien Dolby Digital or DTS is decoded are also directed to this jack in accordance
w ith your SPEAKER SET selections.
Notes
The cut-off frequency of the SUBWOOFER jack is 90 Hz.
If you do not use a subwoofer, allocate the signals to the front left and right speakers by changing the setting of "SOUND I
SPEAKER SET” item “ID BASS" on the set menu to FRONT.
- - - -
Use the control on the suhw'oofer to adjust its volume level. You can also adjust the volume level hy using this unit’s remote control
(see "SETTING THE SPEAKER LEVELS" on page 50).
17